─ KARBOMİT
Karbomit Panel Tile Sheet
─ KARBOMİT
Technicial Spesifications
| Technicial Spesifications | ||
|---|---|---|
| Width | 890 mm | 1040 mm |
| Useful width | 800 mm | 955 mm |
| Length | Desired Length | Desired Length |
| Thickness | 2 mm / 2,5 mm / 3 mm | 2 mm / 2,5 mm / 3 mm |
| Weight | 2,0 mm : 3,30 Kg/m² | 2,0 mm : 3,30 Kg/m² |
| Groove height | 25 mm | |
| Purlin range | 700 mm - 800 mm | |
TOLERANCE
Thickness: ± 0.05 mm
Useful width: ± 3 mm
Length: ± 5 mm
─ Tile Sheet
Accessories and Installation Guide
1
Karbomit Panel Tile Sheet :
First of all, the slope of the roof should be at least 15 degrees and at most 35 degrees.
The purlin spacing should be 70 cm.
Overlap the boards and mount from the overlap point as much as possible.
2
Top Ridge :
In order for the top ridge to be applied properly, the gutter heights of the main boards on both sides of the roof must overlap. The top ridge must then be mounted to the panel boards onb both sides.
3
Side Ridge :
It is used in the edge joints of panel sheets up to the top the roofs in versatile roofs. The ridge should be placed properly so that it closes on both sides.
4
Three-armed ridge :
It is used at the junction points of side ridges and top ridges. In order to apply this ridge, the other ridges must be aligned with each other.
5
Closing Ridge :
It is used to close the end of other ridges after the assembly is finished.